![]() Maybe, someone has answers I'm struggling to find. Hi, I'm trying to build this, and having a little trouble. You don't want to push the nut out of its pocket. Insert the screw from below and carefully tighten. With the Small Mac held together, insert a 3M X 12mm cap screw into the remaining hole on the left. Slide it upward under the tab in the top cover. Move the cover closer to the back, allowing gravity to hold it in place. Place the screen between the tabs on the front cover. Remove the protective cover from the screen. ![]() (If you decide to use the 2.5M nuts and bots, install the card first and then the ribbon cable.) Slide in the retainer clip and screw it in from below. Check the ports are aligned to the openings. Make sure it is aligned and fully inserted.Ĭarefully insert the Pi into the back of the case. The Female connector attaches to the Pi, the Male end to the display. With the SD card installed in your Pi 3, carefully install the ribbon cable as in the photographs. If you are using a Raspberry Pi Zero, follow Step 12: Assembling The Tiny Mac in the original instructable.įor those of you with the Pi 3, use the following steps. waveshare-35dpi-4b.dtbo, waveshare-35dpi-3b.dtbo, waveshare-35dpi-3b-4b.dtbo and vc4-kms-DPI-35inch.dtboĮject your SD card and if building the Pi 3 version, insert it into your Tiny Mac. Looking at the root level, you will see a directory called overlays. Open that directory and drag in the 4 files from Waveshare's zip. This file will tell the Pi to use the Waveshare screen as your default screen. If you don't have rights, you and usually delete the file and add a new one. It will ask you if you want to replace the file. Drag your new config.txt file into the window. This is our backup in case something goes wrong. At the root level you will find a file called config.txt. Make a copy of the file and rename it configOrg.txt. You have access to some of the files used on your Pi. Take your Pi's SD card and insert it into your desktop computer. There is an explication of just what the need changes are. Take a look at the Waveshare documentation. Check out the original Insturctable Step 2 for more details about printing and finishing. I've included the SketchUp file if you want to make changes. The back_supportTest.stl and the front_supportTest.stl files are there if you want to experiment with supports before committing to printing the full parts. The pieces should be oriented correctly for printing.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |